D-Brackets for hanging pictures:

Click here to buy hangITstrips

Sawtooth Brackets for hanging pictures: 

Keyhole Brackets:Keyhole BracketPICTORIAL DIRECTION

Click here to buy hangITstrips

Keyhole Brackets for hanging pictures:

Click here to buy hangITstrips

Pictorial Directions

D-Brackets for hanging pictures: 

1. Place the picture or artwork face down on a clean working surface. Thread the smaller hourglass end of the hangITstrip through the bottom of the D-ring. Remove  the liner from the adhesive on the hourglass end. Fold over and adhere to itself, while making sure the narrow point of the hourglass cutout is at the tip of the D-ring where the nail will go.

2. Repeat step one for the other d-bracket. See steps 3-6 below.

Sawtooth Brackets for hanging pictures:

1. Place the picture or artwork face down on a clean working surface. Thread the smaller end of the hangITstrip under the sawtooth bracket. Peel the liner off the hourglass end of the strip and adhere it on the back of the artwork adjacent to where the nail needs to go on the sawtooth bracket.

2. Repeat step one for the other sawtooth bracket. See steps 3-6 below.

Keyhole Brackets for hanging pictures:

1. Place the picture or artwork face down on a clean working surface. Remove the liner from the adhesive on the hourglass end of the strip and place the narrow part of the hourglass shape right at the top of the keyhole where the nail needs to go.

2. Repeat step one for the other keyhole. See steps 3-6 below. 

Picture Wire for hanging pictures:

1. Place the picture or artwork face down on a clean working surface. Determine the center of gravity by measuring the width of the frame. Remove the paper liner from the adhesive on the hourglass end and position the hangITstrip with narrow point of hour glass cut-out on the center of the wire where you want the nail to go. See steps 3-6 below. 

Steps 3-6:

3. Place the picture or artwork on the wall at desired location with the hangITstrip positioned above the frame; check for levelness. Remove the liner exposing the adhesive on the top of each hangITstrip, pull each strip tight and adhere to the wall.

4. Gently pull down on frame causing the strip(s) to break at the weak point of hour glass cut-out.

5. Install nail or screw at the tip of each hangITstrip.

6. Remove the hangITstrips from the wall and hang the artwork. 

Thank you for hanging pictures fast and easy with hangITstrips!